CARBIDE TIPPED SINK AND TRIM WITH ULTRA-GLIDE

Amana Tool®

This bit is designed specifically for use for the Karran stainless steel edgesinks for laminate and 1/2" solid surface materials. They trim the counter-top edge after the bowl is mounted.Trim a sink cutout flush with the bowl in stages using these "over-hang" and flush trim bits in tandem. The overhang bits are equipped with non-marring Ultra-Glide™ bearings that are tapered to match the slope of the bowl's side. A first pass with the appropriate overhang bit cleans the cutout edge, leaving a very slight overhang at the underside of the counter. A pass with the flush-trim bit completes the operation.
SKU# A-57155
.00

1/2 WHITE MELAMINE 2S at House of Lumber Long Beach...

1D 1/2S ROMAN OGEE at House of Lumber Long Beach...

NO BLUSH PLUS RETARDER SPRAY at House of Lumber Long Beach...

TONER FINISH LQR SANDING SEALER at House of Lumber Long Beach...