EDGE FORMING BIT 1/2 SHK

Amana Tool®

These bits are designed for routing architectural and furniture moldings and trim. Almost all have the profile laid out vertically, reducing the diameter of the bit. These bits should be used in a 2+ horsepower, table-mounted router, and many should be run at reduced speed. Although most have ball-bearing guides, guiding the cuts with the fence is recommended.
SKU# A-54234
.50

VAN DYKE WALNUT ULTRACLASSIC TONER at House of Lumber Long Beach...

EA-DIAL SLOTTING CUTTER 1/4-1/2 at House of Lumber Long Beach...

"SINGLE TRACK 150E 10"" MILL FINISH" at House of Lumber Long Beach...

ULTRA MARK LIGHT OAK+++ at House of Lumber Long Beach...