CLASSICAL Molding 1/2 SHK

Amana Tool®

These bits are designed for routing architectural and furniture moldings and trim. Almost all have the profile laid out vertically, reducing the diameter of the bit. These bits should be used in a 2+ horsepower, table-mounted router, and many should be run at reduced speed. Although most have ball-bearing guides, guiding the cuts with the fence is recommended.Maximum RPM 12,000.
SKU# A-54220
.76

ROUNDING OVER BIT 3/4 RADIUS at House of Lumber Long Beach...

Raw Umber UTC 824-2003 at House of Lumber Long Beach...

GA RED OAK FAMOWOOD at House of Lumber Long Beach...

3/8D 1/4S 2F FLUSH TRIM at House of Lumber Long Beach...