CARBIDE TIPPED SINK AND TRIM WITH ULTRA-GLIDE

Amana Tool®

This bit is designed specifically for use for the Karran stainless steel edgesinks for laminate and 1/2" solid surface materials. They trim the counter-top edge after the bowl is mounted.Trim a sink cutout flush with the bowl in stages using these "over-hang" and flush trim bits in tandem. The overhang bits are equipped with non-marring Ultra-Glide™ bearings that are tapered to match the slope of the bowl's side. A first pass with the appropriate overhang bit cleans the cutout edge, leaving a very slight overhang at the underside of the counter. A pass with the flush-trim bit completes the operation.
SKU# A-57155
.00
CARBIDE TIPPED COMBINATION RIPPING AND CROSSCUT 10 INCH DIA x 50T 4+1, 15 DEG, 5/8 BORE

CARBIDE TIPPED COMBINATION RIPPING AND CROSSCUT 10 INCH DIA x 50T 4+1, 15 DEG, 5/8 BORE at House of Lumber Long Beach...

CARBIDE TIPPED UNDERMOUNT BOWL SOLID SURFACE at House of Lumber Long Beach...

Drawer Slide Jig (KHI-SLIDE) at House of Lumber Long Beach...

CARBIDE TIPPED PLASTIC 10 INCH DIA x 80T M-TCG, -2 DEG, 5/8 BORE CIRCULAR SAW BLADE at House of Lumber Long Beach...